We're Sorry, Full Content Access is for Members Only...

If you like to keep on reading, Become a Member Now! Here is Why:

  • Learn any CCNA, CCNP and CCIE R&S Topic. Explained As Simple As Possible.
  • Try for Just $1. The Best Dollar You've Ever Spent on Your Cisco Career!
  • Full Access to our 639 Lessons. More Lessons Added Every Week!
  • Content created by Rene Molenaar (CCIE #41726)

 

355 New Members signed up the last 30 days!

satisfaction-guaranteed

100% Satisfaction Guaranteed!
You may cancel your monthly membership at any time.
No Questions Asked!


Forum Replies

  1. Hello Ashok.

    You probably mean www.gns3vault.com. You can register by going to this link: https://gns3vault.com/registration/. It was a little hard to find, but the link is available on the right in the login box under the Labs, Blog, FAQ or Contact tabs.

    I hope this has been helpful!

    Laz

  2. EDIT: Solved. There are two sets of links, however as I found the labs via another website I was not aware there were two - so chose the wrong ones.

    Hi Guys, I’ve downloaded the gns3vault topology and have started troubleshooting ticket #1 - but nothing is broken. The client can ping successfully, and it automatically gets a DHCP address without any “troubleshooting” required.

    I’ve partially read the solution to check I’m not missing anything, and have found that the DHCP pool which should be mis-configured, is already correct. Have corrected versions of the co

    ... Continue reading in our forum

  3. Hello Zeko

    Make sure that you’re using the latest version of GNS3 as older versions will not work well with some of the labs in the GNS3Vault. Also, take a look at this thread from the gns3 discussions forum, you might find a solution or workaround there as well.

    I hope this has been helpful!

    Laz

  4. Hi Zeko,

    If you build your own topology, you can still use my configs:

    https://gns3vault.com/wp-content/uploads/2011/10/tshoot-topology-2.zip

    Unzip that file and search for *.cfg and you’ll find all my files. Here’s the VLAN 10 config of DSW10:

    interface Vlan10
     ip address 10.2.1.1 255.255.255.0
     ip helper-address 10.1.4.5
     ipv6 address FE80::C00B:13FF:FEE1:1 link-local
     ipv6 address 2026::3:1/122
     ipv6 rip RIPNG enable
     standby 10 ip 10.2.1.254
     standby 10 priority 120
     standby 10 preempt

    So yes, it does have RIPNG enabled.

    Rene

  5. i got it working i have done on the SVI 10 :blush: . thanks Sir Rene

15 more replies! Ask a question or join the discussion by visiting our Community Forum